Interested to Buy Any Domain ? << Click Here >> for more details...
what is the differance beetwen installation and errection ?
- 1 Answers
- 3775 Views
- I also Faced
- E-Mail Answers
Answer Posted / vsrinivas
Installation
. Erect the m/c as per drawing with safety with
out damage of m/c.
Commissioning
. the same m/c handover to the costumer with
good working condition.
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
Best way to measure the Soil resistance of rocky soil, three probe method and four probe method
how to read idmt curva
I just purchased a 4 position cam switch to be used to operate a 3-speed blower motor. The motor is a 10 amp motor and has 3 wires that are used to control speed. The cam switch was rated at 660V 20 amps but when I received it, I noticed that it has AC-15 operational current rating (Ie) of 4/5 amps. If I am reading the label correctly. the 4/5 amps is related to 440v/220V (Ue). Other ratings are AC-3: 5.5A, AC2: 7.5A and AC-4: 1.5A. My questions are 1) Is it safe to use this switch with the motor I have 2) what is the difference between the 20 amp Ith ratting and the Ie operational ratings?
When a single pase capacitor run motor- run on 230vac and Case(1)run with 8 Mfd 250 vac.capacitor , Case( 2) run with 8 Mfd 400vac capacitor. What is difference between both case regarding power ,efficiency etc?
For some transformers we are using solid neutral earthing while some others we are using resistance earthing why ?
Can any one give an explanation about rating factors of cable? if we are laying the cable on the air with an temp 15 degree then rating factors will be 1.15 and if we are laying the cable on the air an temp 60 degree then rating factor will be 0.76 please describe it and what is the difference between rating factor and derating factor?
Two liquids hot and cold in two vessels are there and an metal bar acts as a conductor of heat between the two vessels. what happens then. what happens after 24 hrs?
why do we not use equivalent voltage source in negative sequence equivalent ckt.
How to calculate the phase to phase clearness of HT /// LT bus bar?????
State angle criterion.
how we provide neutral earth on synchronising panel as per electrical standards?
how we can calculate power factor in single phase & three phase ?thank u
what is power factor ? how we can calculate the low power factor and amount of capacitor for improve that low factor ?
If we have use two power cable for incomer, that time how many use cbct for earth leakage protection? 1 or 2 if 1 way? If 2 way?
i need the details about bhel exam.how to apply for that.please send to my email-id.thenmozhi2k7@gmail.com
