Interested to Buy Any Domain ? << Click Here >> for more details...
what is hot loop check and cold loop check.
- 3 Answers
- 10952 Views
- Bapco Bahrain Petroleum Company, I also Faced
- E-Mail Answers
Answer Posted / guest
A Cold Loop check is cold because it is done without
powering the loop.
A cold check consists of checking wire continuity from the
field instrument through junction boxes and through DCS/PLC
marshalling panel terminals to the control panel. Once
continuity has been confirmed, then a Hot Loop Check is
performed on the Loop's I/O.
A Hot loop check is 'hot' because it is done with the loop
powered up.
A Hot loop check consists of
- simulating a process input at the field instrument and
then checking the instrument's output and the response to
the process signal input at DCS/PLC.
- simulating outputs at the control end and checking for
correct response at the field end.
Carl Ellis
Measure First
| Is This Answer Correct ? | 13 Yes | 1 No |
Post New Answer View All Answers
how will you check torque value during Factory acceptance Test for control valve/ESD ON/OFF VALE how will you confirm this torque value is being correct, Which document will you be refer.
what is the imbustion control loop
hye SAM acn u send your e mail id, so that i can solve my query through e mail?
Operational amplifiers
what is Best Among SINK Or SOURCE Type Design In Digital Signal, Either Iput Or Output? WHY?Can any one..
sir ,iam in dem urgent need of HPCL Paper of Instrumentation Branch plz send me at your earliest convenience at ujjwal_sharma1983@yahoo.com
this site is owned by an nonsense
can we create an interrupt in plc through scada?
dear friends, i have seen flow as the selection critriea in presure guage (bourdon tube) and i would like to know what is the relation between flow and performance of pressure guage other parameters i found in the data sheet are pressure max. 1ksc temperature max. - 50 deg c line size - 80NB operating range - 1ksc pr. guage range - 0-2 ksc thank u,
Linear amplifier.
How r the calculation of process line mpm.
hi my name is rakesh patel i just complited my be in instrumentation & control now i am going to working as a validation engineer in a poject department so what is a scope in a future as a validation engginer ? what line is good for me can any bady give me complete solution please? your regard rakesh patel
Explain the burnout feature.
What is the difference between uv and ir scanners? and what is the workig principle of both
How to Calibrate Flow Switch in field
