Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / md waseem khan
Shunt trips are devices used for the remote
instantaneous opening of the air circuit
breaker. They are generally controlled trough
an N/O type contact. The actual offer of
shunt trips proposes two supply voltages
(110 V and 220 V), both compatibles with AC
and DC currents. The shunt trips are already
equipped with a special fast connector, to
be directly inserted into auxiliary contacts
block. An auxiliary contact is connected in
series with the coil, cutting off its power
supply when the main poles are open.
| Is This Answer Correct ? | 9 Yes | 2 No |
Post New Answer View All Answers
Plz tell me how we can find that particular company has vacancy or not
if two transformers are placed parallel & both have fault impedance of 50KA will it increase or decrease show example?
STATE USE OF ARC RUNNERS & SPLITTERS ?
WHAT IS SHORT CIRCUIT STRENGTH OF 100 AMPS MCCB?
hello friends this is krunal here.. i have applied for he officer train in hpcl electrical stream.. any one who have applied before for electrical stream please help me out.. post ur reply to my mail id: krunal_airforce@yahoo.com.. any tips, old questions for paper or any help will do.. plz help me.. your faithfully, Krunal Darji
in non technical way how can u define POWER FACTOR??
Trafo ratio is 11kV/6.6kv,Vector group is YND11. What will be the effect if secondary is used for earthed system.
Benifits of 3ph 4 wire metering over 3ph 3 wire
diff.between servo motor and ac motor
The power supplied to a 50mH inductor from a 120V, 60Hz source will be
Define norton equivalent circuit?
How to Decide(calculate) Bush bar size for copper and aluminiam ?
why the India electrical supply transmission loss is high when compare to us
What is true sine wave or pure sine wave inverter?? Is it sine wave or step wave?? If it is step wave, waves with how much step is considered as pure sine wave? Is it possible to produce pure sinewave using power electronics?
I have doubt that the supply HZ (very low or high than rated ) may affect the power factor. is it true. ?
