what is the difference between the heat exchanger and
cooling tower???????????
- 10 Answers
- 26691 Views
- BARC, Essar, I also Faced
- E-Mail Answers
Answer Posted / kumar phanishwar
there are two types of heat exchangers based on the type of
interaction between fluid:
1. Direct Contact
2. Indirect Contact
Shell & Tube as well as plate type heat exchangers are
indirect contact heat exchangers as heat transfer is through
the surface separating two fluids.
Cooling tower in a direct contact heat exchanger.
In this type of heat exchanger fluids mix with each other
and transfer heat as well as mass.
| Is This Answer Correct ? | 2 Yes | 1 No |
Post New Answer View All Answers
why screw compressor use for ammonia compression?
What are the advantages of using gear pumps?
What are the assumptions made for kynch theory?
need the type of technical questions in written test
Explain what are some good uses of low-grade steam at 12 atm and 1920c?
How do you design a vapor-liquid separator or a flash drum?
can anyone send me the written test paper of Indian oil corporation ltd. My email id is pratuljakhmola@yahoo.com
What is a good estimate for the absolute roughness for epoxy lined carbon steel pipe?
What is the angle of repose and what are its applications in the chemical industry?
what is the cast iron grade of composition of c-3.06% , Mn- 0.48% , Si-2.38% , S-0.088% , P-0.092% , Cr-0.12% , Ni- 0.012% , Mo-0.00%
i am appearing in railway section engg. exam of chemical eng. therefore i want previous papers and study material of chemical eng.
Given, T1=600C, constant temperature of wall 800 , length of wit exchanger L=3m, dia=25 mm, Cp=14.91 KJ/kg.K, density ρ=914 kg/m3,mean velocity vm= 2 m/s, film heat transfer coefficient hf=72 Kcal/h.m2.K, what is the outlet temperature?
i need last year question paper of GATE exam of chemical stream.but i failed i geting exam papers.soits humble request to u that if any body found last years GATE exam paper of chemical stream then send it to on this mail address.i shall be thankful to u for this. mail address:- sachin_4255@yahoo.co.in thank you.
What is a good method of steam tracing large vessels?
What are some guidelines for sizing a psv for a fire scenario on a vessel in a refinery service?
