4.In which type of welding is a pool of molten metal used.....
- 3 Answers
- 20624 Views
- ISRO, SSC, Vizag Steel, I also Faced
- E-Mail Answers
Answer Posted / ab
it is ELECTRO SLAG WELDING
| Is This Answer Correct ? | 63 Yes | 25 No |
Post New Answer View All Answers
1) why a dg set shows variation of power factor and load when synchronised with other dgs? 2)Why the load sharing is not become equal in all dgs?. 3)When a dg set will not run on auto start?
How to calculate phase to phase difference ?
diff. between tension mode & speed mode
What is knee point voltage of transformer?
What happens to voltage when current through the inductor is constant?
What is the lower limit of break-down voltage of converter transformer.
What must be the minimum distance maintained between 2 Generators as per International standards?
which one is more efficient, torq, power & ecnomy with the same frame size AC motor / DC motor?
What is the tipical Online UPS input voltage for 20 KVA load ( 3 Phase or 1 Phase )? Why ? Explain it...?
how mass curve differs from hydrograph.
Why different Pressure switch used in marine boiler water circulation system
how much UPS neutral erath leakage current.
A 230V dc shunt wound motor has an armature resistance of 0,15Ω.When operating on no load at 650 rev/min the armature current is 6A . The motor takes a full load current of 85A. Calculate the full load speed if the field flux is (i) maintained constant (ii)reduced by 0,03
i am electrical and elctronics engg passed out in 2009 want to attend for reliance placements.plz send me apttitude ,technical and hr question answers to my mail plz. my mail id-kat.bindas@gmail.com
I am using submission of two ct in one and half scheme for 67/67N protection. Both CTs star point is grounded separately near ct box.Will two point ground give wrong tripping to 67/67N during fault or no matter.
