Interested to Buy Any Domain ? << Click Here >> for more details...
What is the difference between compensation and extension cable.
- 11 Answers
- 38649 Views
- HPCL, I also Faced
- E-Mail Answers
Answer Posted / farhad rabiee roudsari
When connecting thermocouples to instruments, it is
essential that a cable is used, which has the same emf
output as the thermocouple; otherwise spurious emf is
generated at these junctions. The best solution is to use
the same material as the thermocouple (extension cable). A
cheaper alternative is to use compensating cables, the
alloys of which are different from those of the thermocouple
but have the same output over a limited temperature range.
| Is This Answer Correct ? | 13 Yes | 1 No |
Post New Answer View All Answers
what is stroke check for field instument transmetter's & AOV's
how to convert MA in to measuring values..and how mwasuring values into MA ?..plz ansr.i have intervw
what is function of SCADA , and how is it work, explain with difination
What is 3 element control system
please send the drdo exam paper
What are the uses of orifice plates?
What is the difference bitween control net scaner and device net scaner
dear friends, i have seen flow as the selection critriea in presure guage (bourdon tube) and i would like to know what is the relation between flow and performance of pressure guage other parameters i found in the data sheet are pressure max. 1ksc temperature max. - 50 deg c line size - 80NB operating range - 1ksc pr. guage range - 0-2 ksc thank u,
send me last 5 years questions asked in rrb chennai, for section engineer
how to rectify the poor signal strength in utrasonic digtial flow meter ,model:ge digital xce868i
when placing a vent or drain hole on an orifice plate should you measure from the center of the bore up or down for the vent placement?
A DP transmitter is used to measure the level of an open tank. The drain line of the tank is connected to a control valve, and is configured as, if the level of the tank is 90% the valve should get open 10%. And if the tank level is 10%, the valve should get open 90%. Draw wiring diagram and explain how to configure DP transmitter and control valve using HART communicator. If the span error at output is 1%, what will be the %opening of the control valve at 60% level of the tank?
What is the cascade control
I have 0.75mm sq multicore cable (IS type) , can use instead of same type but 1.5 sq mm cable ? Note : The distance is around about 150 meter.
Which types of quections asked in interview for FORMULATION PLANT (PHARMA)
