What is the difference between MPCB and OLR?
Answer Posted / mohammed abdul naeem
1. MPCB is Trip by (Auxiliary Block Contact.)
2. OLR is Trip by Thermal (heating by range setting)
| Is This Answer Correct ? | 4 Yes | 1 No |
Post New Answer View All Answers
How to checked frequency drive output voltages?
Give the topology of current amplifier with current shunt feedback?
The screw thread commonly used for transmission of motion is one of the following types of threads
how to find 5 kilo meter long under ground 33 kv cable fault location if IR VALUE shows 0.05 M ohm @5000 volt.and cable fault locator shows some time fault distance 3 kilo meter ,3.7 kilo meter and some time 1 kilo meter? now how to find the fault location that where is leakage. note--it is tested with 5000 kv megger and insulation resistance is 0.05 M ohm. and some time 0.03 M ohm comes.
In case of generator when we consume more power produces by it why load on generator increase and starts sound more. and how it is adjusted..
100 MVA 3-phase alternator with earthed neutral has a reactance of 5 ohms per phase. what will be the fault MVA of generator.
what is the condition for YnD11
Briefly define and explain the following different types of Pulse Amplitude Modulation (PAM) with some examples. i) 2-PAM ii) 4-PAM iii) 8-PAM iv) 16-PAM v) Quadrature Amplitude Modulation (QAM)
if any house we instaled a 1.5 ton ac and its phase cable of wiring is installed but netrual cable of wiring not instaed. my question is that is neutual of house(for other wiring is capable for ac load or a sepeart neutrual wiring required
What is a dc motor?
how to conduct dc resistance test for rotor of an alternator and how to measure the rotor dc resistance value theoritically?
1.how many earth pits are required for 1000 k.w plant include substion , transformer ? 2. how many earth pits are required for 500kva generator.what is formula to calcute?
A cylindrical wire is compressed in length by 10%. The percentage decrease in the resistance will be?????
What are the ratings of VCB, MCB, MCCB, SF6, ACB, and OCB?
What is the difference between type1 and type2 relay protection co-ordination for motor feeders