Interested to Buy Any Domain ? << Click Here >> for more details...
in a plug point why the hole size at the top is large?
- 9 Answers
- 13709 Views
- Bhel, TCS, I also Faced
- E-Mail Answers
Answer Posted / tharanidharan a
In a three pin plug ,the base two pins arranged serially are
PHASE and NEUTRAL. and the top most large sized pin is made
for grounding purpose which is used to protect the device from
shorts(high and low voltages)
example:
when a three point charger is inserted the top larger pin will
touch first than the rest so that the device is prevented by
ground
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
what is the problem when i want to close a circuit breaker by local position it closes well.but when i close it in remote position it trips
I am about to write exam in RRB bangalore for the post of section engineer.please provide me with previous exam questions
How I can Compare 120v/60Hz versus 220v/50Hz ? Please tell me both advantage and disadvantage ......
hi i have applied for lic of india south cenrtal zonal ,hyd. i didnt get hall ticket till now.let me know how can i get form internet
What difference between ref protection and differential protection ?
what is Fault level? why it is calculated? how will u decide same for our plant?
how the B-H loop obtain under the static condition
Why ground terminal is used in pot meter 10k ohms
What is the use for cable entry in control room?
how to measure earth resistance of a substation
3- What is the target from Zero Impedance, Single Phase Imp., S/C Imp. and magnetic balance tests?
A 15 kw squirrel cage motor having a maximum efficiency of 90% on a continuous full load has temperature rise of 42 degrees celcius after 30 min and 52 degrees celcius after 1 hr under the above operation conditions. a) calculate its final steady state temperature rise on continuous load and the heating time constatnt. b) if the motor is operated on a short load for 9 min estimate its temperature rise. c) calculate the maximum overload that can be applied on a short, 9 min rating so that the temperature rise is the same as the final steady state temperature rise on continuous load.
Why it need to form a capcitor when it not been in use from three or two year. Plz describe it technically.
cc of scorpio?
WHAT SHOULD BE THE BEST CURRENT RATINGS (PRIMARY / SECONDARY)FOR A CT INSTALLED AT THE INCOMING 11KV PANE? WILL IT BE CALCULATED ON THE BASES OF MAXIMUM DEMANT VALUE OR ON SUM OF ALL TRANSFORMER'S KVA? NOMALLY MAX DEMAND REPRESENT THE MAXIMUM OPERATING LOAD OF THE PLANT AND TOTAL KVA OF (SAY 5 NUMBERS TRANSFORMERS) REPRESENT THE CONNECTED LOAD. WHICH i.e. MAX DEMAND KVA OR CONNECTED KVA ARE BETTER TO USE FOR CT CURRENT CALCULATION? PLEASE ANSWER.
