Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / purushottam kumar
for constant power and terminal voltage ,if power factor is low current drawn is more ,so more lose ocour ,regulation is poor, conductor size increased than with high power factor
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
Define gain margin?
A system absorbs 100 k J of heat and the increase in its internal energy is 100 kJ; the work done is
Define phase cross over?
what precautions to be taken while desigining a LT,HT panel. Eg-LT panel PCC panel with ACB installed. HT panel VCB panel with VCB installed. & what is main diffrence betwn IP54 & IP55 construction of panel.
Do you need any help with FEWA Electrical Supervisor exams?
what is two point starter?
What will be electrical cost per sqft for IT building (basebuild and fitout)and for residential township?
Air circuit breaker safety
What is a differential amplifier?
can any one tell in easy method for circulating current ??
how to select correct size of power cable for inverter duty motor
what is the synchronous timer ? and it applications.
Is there a possibility to use such a treshold voltage for the NMOS part of a CMOS circuit that during the switching it will start conducting only after the PMOS part will be already closed, by this eliminating the leakedge current? Please note, I'm not asking about the well bias in standby mode, but about the "antileakedge" measures during normal operation.
how is the incoming cable size calculated for a given current rating of a panel??
for 100 HP Induction motor service factor is 1.2(SF) we placed a VFD at the motor side load is balance with 0.3 Amp's Phase to Phase but at incoming of VFD load is un-balance with 10 to 20 Amp's what will be cause of load un balance
