Interested to Buy Any Domain ? << Click Here >> for more details...
How to check vortex flow meter is in good condition while
we do not having calibration setup?
- 4 Answers
- 8757 Views
- I also Faced
- E-Mail Answers
Answer Posted / tuhin
@soumil: no hp and lp side exist in vortex flowmeter. Vortex
principle is different.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
Q- What are the application in which PNP transistor is preferred over NPN ?
(1) In turbine, what does term CDP, NI, NH, HSSOC, means. (2) What is the purpose of LO overhead tank in turbines.(3) An equipment is certified for EEX, IA, IIC,T6, what do you under stand by this.(4) what is SURGE, and how it is prevented, what is the purpose of bypass valve across AS valve.(5) Give 2 application of quartz crystal used for process parameter measurement.(6) what is meant by cold float of compressor shaft. (7) state four different types of flow measurement. For gas flow measurement mmscfd is the common unit. Expand the unit and specify significance of word S in the unit.(8) what is meant by Gap voltage, in vibration measurement. Normally how much Gap voltage is set and state the reason.(9) what will the new flow factor if D/P transmitter is Re-Ranged from 25” wc to 50” wc.(10) what is the usage of QDV & Volume booster.
SOME OF YOUR QUESTIONS ARE NOT MAKING ANY SENSE SO TRY AND PUT IN A LITTLE BIT MORE EFFORT BEFORE YOU POST A QUESTION. WE WILL ONLY HELP THOSE WHO WE CAN SEE ARE TRYING TO HELP THEMSELVES.
Draw a simple circuit for a well head control panel used to protect the well against fire, leak, blockage, ESD, & controls the operation of one downhole & one surface safety valve. Explain the operation and controls
protection relay watchdog contact operation?
Displace type LT to be calibrated in workshop, wt. 40, dia- 60 mm, density- 0.8kg/cm3.
What happen if I install my pressure transmitter below the elevation of pipe in natural gas service?
how can we tune a PID. If it is by zeiger nichols method..please explain briefly with help of an example.
How does temperature bath work? How does coil gets heated only by applying some current?
Any one can help me to identified, how can we interchange the device in FF
Instrumentation symbols interpration, P& ID, Logic diagram analysis, Electrical drawing analysis.
Explain the working of an enraf level gauge.
what is IEC code in cables & how to selecting cables?
what will the sending unit in the fuel gauge utilizes?
What is difference between ESD and PLC please Explain me clearly.
