what is the ground clearance of 400KV transmission line?
Answer Posted / sutapa
Rohit Sing is a pure GANDU.......... Pls click yes or no
| Is This Answer Correct ? | 13 Yes | 3 No |
Post New Answer View All Answers
7- What is the Dissipation Factor and the difference between it and Insulation Resistance Test? 8- What is the task (function) of DC and AC reactors in power plant? 9- What is the task (function) of (open delta with earthed) in some types in transformers? 10- What is the base of the selection of the vector group in transformers? 11- What is the zig-zag transformer and its function by drawing in large detail? 12- What is the polarity ? 13- Why we make short between phase(R) in high side and phase (r) in low side in vector group test? Where High Side ( R ,S and T ) and Low Side ( r ,s and t ). 14- What are the time on delay and time off delay? 15- What is the vector group? 15- What is the task (function) of different types of vector group such as Dyn11 , Dd0 , YNd1,……..,?
What is the emf equation of a transformer?
WHY MOSTLY Rph IS USED FOR CONTROL CIRCUITS AUX. SUPPLY ?
which pump used in WTP explain the function of VFD how to dtermine capacitorbank of capacity one plant
Thumb rule of cable size(rm>30 rm)X multiplying factor=ampere
FEINGING DECREASES THE FLUX DENSITY IN THE AIR GAP. HOW?
What type of DC motor would you see for a lift?
In Power Line Communication (PLC) the wave trap is used to block communication signals from entering neighboring lines. My question is this: Why do they allow for different filtering arrangements on these wave traps? Isn't it always going to be a low pass filter since we want the power frequency to go through, and the comm signal blocked?
how many load we can take for lighting
Formulae for calculating the transmission line losses for different voltage levels
Difference between Earthing Truck & Earthing trolly for HT panel
Load break swicth maintenance procedure.
What are the Return ( Monthly / quarterly/ Annual submitted to Electical Inspector for an establishment (Factory in Maharashtra-- Small scale category having seperate HT line of 22KV ) as per Maharashtra Electricity Act
Dear All, I am new in construction company , my boss ask a question at time of interview , If we have 60MW generation and Single Power Transformer step-up we have. if CMR 50/60MVA , ONAN, ONAF respectively , is it sufficient or not ? for that much power to transfer,
Why squirrel cage motor can only use with low starting loads ?