i have D.p. transmitter of range 0 to 2540 mmWC, i want to
use this for flow measurement (0 to 500 ltr/hr.) what
should i do?
- 9 Answers
- 22968 Views
- I also Faced
- E-Mail Answers
Answer Posted / jigarsinh vaghela
First of all Good Question
Ans: Use Orifice Bore Calculation sheet
you want process data like pipe size, Max Temp, Max Pressure,
Max Flow rate & Application like Steam or water
put this values in OPA Calculation sheet & you would got dp
range in MMWC
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
What is the difference between PLC and DDC?
WHAT IS THE CAM POSITION IN CONTROL VALVE POSITIONER ? WHY IT IS USED?
Specify eight technical requirements that you would consider important, when deciding upon a particular control valve?
what is dc moter.
What are primary elements of measuring pressure?
Drum level tx with GP4 with zero elevation:7300mmh20 on HP and 8050mmh2o on LP as range but on commissioning the tx readiing is max,Why this reading?
What is Cavitation in a control valve?
pls suggest suitable MOC of diaphragm for pressure measurement of UREA grade solution service fluid.
Describe the typical instrumentation used in monitoring the performance of a shell and tube heat exchanger.
What is the principle of capacitance type level transmitter?
For crude application in floating roof tank, how to calibrate a DP Transmitter? How is the floating roof weight considered?
What is the start up procedure of desalter
What is the use of temperature compensation?
Using your own examples solve a problem involving normal table. (experimental method and analysis)
why we are using magnet for calibration of gas detector?
