Interested to Buy Any Domain ? << Click Here >> for more details...
Capacitor panel CT is normally fixed on Y phase of the main
panel.why???
- 3 Answers
- 9058 Views
- I also Faced
- E-Mail Answers
Answer Posted / rajendra.s
Thanks Zia Mam,For Sharing Additional information,but what about the manufacturing relay companys who manufacture the relay which has R,Y,B phase Selection of CT which i have mentioned in above answer,should we select our relay as per our Phase Load.
From-Rajendra Sawant
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
We have drive feeding an output contactor for a 5000 hp motor @ 5kV application. The motor FLA is 629amps x 1.25% service factor = 786.25 amps The cable that we current have in place between the drive and the output contactor is 350kcmil- MV-105 (parallel cables). Per the NEC table 310.60 (C) (69). This show the cable ampacity is at 615 amps per cable for a rating of 1230 amps. We have derated the cable for the cable tray and the multiple cables application and our calculations show that after the correction factor factor we are at 922amps. 1230 amps x .75% correction factor factor = 922.5 amps. The customer is driving us to then use another safety factor of .25% off of the already derated cable. Can you please provide a longhand calculation for your solution on this application?
how to identify conection leads of an unknown electric motor
what curve and rateing would you use for a three phase 0.75kw motor?
how we can calculate power factor in single phase & three phase ?thank u
trasnfarmaer core make
what is the differencce inn series and cascade connection??
why do you add the load short circuit impedance when considering short circuit amperage. It seems that you should only consider supply. If you need to consider loads and you don't know what loads are to be added , what would be a good sub-transient reactance rating for the loads?
Give some differences between open loop and closed loop?
how we arrange the hv side with delta connection in case 33/11kv of transformer.
Explain the propagation of harmonics in the network and influence of phase angle of harmonics.
what is under coal gassification?
which type of cabel
i have seen one 8.4 MW synchronous motor in a plant located in bellary it is fixed with brushless rotary rectifier ,anybody can explain its start up principle
How to calculate the multiplying factor for energy meter with ct ratio given
how can i get an electrical c-certificate?
