Interested to Buy Any Domain ? << Click Here >> for more details...
SIR MAY I KNOW IF RADAR TYPE LEVEL TRANSMITTER SHOWING IN
THE FIELD 0 % LEVEL AND IN DCS SHOWING 100% THEN WHAT IS THE
CAUSE I CLEAN THE CHAMBER & TAKEN ONLINE BUT ONLY ONCE ITS
BECOME ZERO IN DCS BUT AGAIN 100% SHOWING IN DCS,THEN I
REMOVE THE POWER SUPLLY AND CONNECT IT AGAIN .IS IT OK BUT
STILL IN THE DCS ITS 100% AND ON THE DISPLAY ITS
INITILAZIATION PLEASE HELP ME READRING THIS?
- 4 Answers
- 7627 Views
- I also Faced
- E-Mail Answers
Answer Posted / prakash malviya
first u have 2 remove o/p wires of 4-20 ma then connect ma source with parellel this.then give 4& 20 ma...at 4 u see 0 %lvl & at 20 u find 100% lvl in dcs.if can't then u have 2 check from dcs side.in dcs check AI card particular channel for this.check wires grounding.
2nd condition if u find proper response in dcs with ma given to o/p wires..then go to the radar menu ..go to configuration..in that u find tank lvl...select full...then save it..
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
when the instrument tapping on pipe line is located below and transmitter is located above the tapping point for liquid service transmitter, what should we do, is there any additional drain valve is required??
What is the constant voltage unit?
State four different types of flow measurement, for gas flow measurement MMSCFD is the common unit expand the unit and specify significance of word S in the unit.
What is the purpose of LO Overhead tank in turbines.
basic connection and principle of axial shift sensor n differential sensors in tubine describes n draw......
how many pulses are required by a ac induction servo motor of 4 poles with 50 Hz frequency to rotate by 1 degree?
What is the diffrence between digital signal processing and discrete signal processing?
Hi, I am Newely Joined in Construction company instrument engineer? Any one can Plz tell me How can I advanced preparation for Releated Engineering and construction Documents?
give eg of how I/P is used in control loops
can any one explain in which term we are flow flow is it volumetric r is it mass? and y
all types of liquid analyzer principle with drawing?
What is the differerence between hysterisis and linearity.
can any one tell me when ongc placement test and its forms is available????/ pls tell me if u know
What is hp & mp seperator .& what is its working principle ?
how pressure transmitter work, what is its principal to measure and how its generate signal. for pressure transmitterinstallation which precautions must be taken ??
