Interested to Buy Any Domain ? << Click Here >> for more details...
how to calculate the temp. of RTD&Thermocouple when we got
some mV r Ohms?if anybody has d chart pls mail the chatrs
to me...
- 1 Answers
- 4539 Views
- I also Faced
- E-Mail Answers
Answer Posted / carl_ellis
1) You can't calculate temperature from millivolts from a
thermocouple without cold junction compensation. The
thermocouple tables only apply when the reading is cold
junction compensated.
2) To determine temperature from a resistance value,
several data are required
- the type of RTD (Pt, nickel, copper)
- the temperature coefficient (the alpha) in Ohms/ohm/DegC
must be given - 0.00385? 0.00392?
- the RTD Standard, IEC, USDoD, DIN 43760 With the base and
the alpha tables are available on the web.
- the Ro, the nominal resistance at 0 deg C
The table you request is specific to the RTD in question.
No data, no table.
Carl Ellis
Measure First
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
How to calibrate Toxic gas detector?
What is the GK Value in Flowmeter?
principle of dead weight tester ?
How do you identify between actual alarm and false alarm in a Temperature Transmitter in SCADA based Control System
We are using Rosemount 5400 series Radar Level Transmitters in all types of Sump Applications having oily water hdrocarbon petrochemical nature. What we are facing the problem frequently is that always getting reading frezzed at some value. If we do power recycling , sometimes it is working . then making same freezing problem. If anybody faced before such type of problem and also having solution , Please give the answer.
How to fix back the valve actuator stem
How to calculate P,I&D value in PID controller ?
Explain signal isolator
what is the reason while warning lamp is on while the engine is cranking?
Why even multiple power supplu r used in instrumentation system?
how to rectify the poor signal strength in utrasonic digtial flow meter ,model:ge digital xce868i
Why not come out analog output in ABB EL3020 when display show correct value
What is 3 selection available when configure the burnout protection for controller
need to calculate flow rate with the help of dp range and orifice bore dia and size. range is 0 to 400 inwc and orifice size is 12 inch 150 # rf and bore dia is 7.180 inch. need to calculation for flow rate
What is shielding effect?
