Answer Posted / ashish gupta
Although the density of free electrons around the positive conductor is less as compared to negative conductor but the electrons are highly concentrated around the curved surface of the positive conductor and hence for same energy that has to be dissipated in corona, the activation energy require to enegerize the electrons to take part in corona will be less in case of positive conductor as compared to negative conductor.
hence due to participation of large no. of high energy electrons around positive conductor in corona as compared to negative polarity we can say that corona losses are higher in positive conductor as compared to negative conductor.
Contact: ashishguptaa164@gmail.com
Is This Answer Correct ? | 6 Yes | 3 No |
Post New Answer View All Answers
why all the feeders are designed in a particular manner ... is there any reason for that???
What is domestic transformer? Draw the connection of domestic transformer.
Is it possible to measure the voltage of a battery from a single terminal?
for a 500 KVA connected load, I calculated 30% of capactor for power correction. Even after using 225 KVR capactor PF is not improving. What could be reason for low Phase correction factor?
what is per unit calculation?looking for simple and strong explanation thk u
what is laser diodes?
What is meant by cold loop test in instrument
How many turns are there in primary winding? (In Transformer)
Can we put 3 layers of cable tray while installing tray
Can you used moeller lzm1 mccb in a dc system with 125vdc and 20ka short circuit current , beside is it have 24 or 48 volt shunt ? Beside how long current can through from An MCB shunt contacts? (like Z7-AS 24 V)?
What size cable (based on voltage drop) is required to supply a 40 A three phase boiler if the wiring system is 75V single insulated cables installed in non-metallic rigid conduit 56m from the main switchboard? Voltage drop in the consumer's mains is 8V.
What is the difference between Droop vs Isoch Control?
What are the commonly used schemes for the bus zone protection?
what are the 4 rules to start the motor?
Define cuttoff frequency?