Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / abhijith
in 4-20ma we can easily check the zero and wire breaking in
transmitter. Analog card accept 1-5v dc supply. thatsy V-IR
I=V/R
V=1V R=250OHMS
1/250 = 4MA
V=2V THEN I=2/250 = 8MA
V=3V THEN I=3/250 =12MA
V=4V THEN I= 4/250 =16MA
V=5V THEN I=5/250 = 20MA.
| Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
what is your eligibility criteria for freashers?
hey any one got the papers of SAIL and HPCL plz do help me by posting them to my mail ID's naren07_87@yaho.co.in, surenarendra@gmail.com
How does temperature bath work? How does coil gets heated only by applying some current?
how to measure oxygen which methods are using?
What are advantages and disadvantage of the ac supply load cell?
When doing a liquid seal on a differential flow transmitter , most of the time the sealing liquid will be heavier then the process fluid. For wich application will the sealing liquid be lighter than the process fluid if transmitter is mounted below the process line.
how can use ram
while am calibrating Drager polytron 2IR flame gas detector occured non zero status.how can i get zero status?
Describe the function of Accumulator into the Pump
where proximity sensor installed on tank in loading arm application
how to calibrate 0- 150 psi presure gauge by dead weght tester
There are two chlorination tonners both are connected to two pressure swithes and the pressure switch is connected to SOV which operates the valve to changeover the tonner selection i.e if pressure one tonner goes low the other tonner should come in line if it is inautomatic selection design a circuit using relays ?
What is force balance principle? State some of its’ advantages.
what is sil (safety integrity level
model question paper of instrumentation for Jindal GET 2010.plz reply sudhanshukumar08@yahoo.com
