Interested to Buy Any Domain ? << Click Here >> for more details...
what is DG synchronization panel
plz explain the working!!!!!!!
- 12 Answers
- 99156 Views
- Kirloskar, Lanco, MPS Techologies, Sedemac, I also Faced
- E-Mail Answers
Answer Posted / t ramesh
Dg sync is two or more Dg connected in parallel. But It's not changing the voltage phase sequence. Frequency, Then in case of power failure 1st
1st auto started the master Dg when this crossed the 80% of load then given the sense to PLC panel after started the 2nd DG and GVM panel check the that DG voltage after closed the breaker in auto condition. Then is sharing the load..
| Is This Answer Correct ? | 7 Yes | 4 No |
Post New Answer View All Answers
In diesel generator how AVR get voltage to excitation. And basic diagram DG EXCITATION CIRCUIT.
What happened if C.T mount at any cable or Bus bar in wrong direction . C.T going on proper work or not . C,T direction is essential thing to properly work.
WHAT IS SPEC OF CLEANROOM MOTOR AND LIGHT FITTINGS?
if we have 320KVA Genset kindly advice how much load we can put it.
on a three-winding transformer relationship delta-delta-star, on third winding why the relationship is a star? what are the advantages and disadvantages? Thank you and please help
How can eliminate noise problem inside temperature controller temp. variation due to contactor chattering problem.
What is the function of interposing current transformer?
What is the difference between Generator Differential Relay and Transformer Differential Relay?
what is star delta starter? how it works? give its control and power diagram.
What is the accepted limit to increase the choosen transformer capacity over the load and why ?
Any one can explaination about calibration with rotating sub standards?
Define closed loop control system.
For group 1 , 2 whather i have to prepare my technical or general studies etc? and im graduate in ee engg. for wht posts im eligible for? please tell me!
In Dyn11 power transformer if any one of the 3 phases connected to earth in star connected side then please explain effect of the current flow in delta connected side of transformer.(In this case if one phase is shorted to ground in star connected side then we observe the current flow in two phases only not three phases in delta connected primary side. Please explain why it is so?)
What will happened if the neutral of secondary of Xformer ( Star point) Note it's above KVA rated Xformer
