Interested to Buy Any Domain ? << Click Here >> for more details...
which motor is used in high mast ( street light) & give the
hight of tower .
- 2 Answers
- 8632 Views
- Construction, Honda, I also Faced
- E-Mail Answers
Answer Posted / jithendra
motor is gear operated (gear box) & it should be suitable for
manual & electrical operation
| Is This Answer Correct ? | 6 Yes | 2 No |
Post New Answer View All Answers
What is the RME and explain the full form and what is the RME work?
An automatic water heater is an example of which type of control system?
what is power factor ? how we can calculate the low power factor and amount of capacitor for improve that low factor ?
i have total 8 dg sets for synchronizing and 2 buscoupler,1 sectoin dg no 1,2,3,and 2 sectoin dg no 4,5,6,and last section dg no 7,8 ....if buscupler no 1 and 2 is off mode ..than dg no 1,2,3,will synchroniz of another dg sets?
How much pf maintan in dg set in 6o% load,when Dg runnig Neutaal Earthing removed what happen.
Explain the method to keep noises low in a control system?
how make megger test for control cable like 12c x 1.5mm and what it apply voltage and test timing details.
What's mean HVF & HAF in Vacuum Circuit Breaker?
The windings of a transformer are divided into several coils, because?
Battery is a voltage source? give one example of current source and why?
Hello Friends, How can we recognize the CT Star Point is S1 or S2 in case of Electro Mechanical Relays and what is meant by Restraining coil in relays and what is the purpose of that.. thank you in advance..
Define bibo stability.
current transformer balance the power level on both sides. e.g in case of step up, at secondary side voltage rise but current decrease and vice versa in case of step down transformer. but how this power level remains same in case of current transformer and voltage transformer
what is the effect of change in supply frequency on load angle of synchronous motor,all other parameters remaining same?
what is mean by NPS (Negative phase sequence)fault? what is the difference between EFR & OCR faults?
