Interested to Buy Any Domain ? << Click Here >> for more details...
KVA transformer of different frequencies of
50hz,100hz,500hz&1000hz. which one of these transformer has
big size? Give reason
- 4 Answers
- 7999 Views
- Suzlon, I also Faced
- E-Mail Answers
Answer Posted / annarapu sairam
At higher frequencies the no of turns required is less so the
size of transformer is reducued.
| Is This Answer Correct ? | 5 Yes | 3 No |
Post New Answer View All Answers
what are problems caused by the pdu in rack server
Alternator rotor earth fault relay circuit
while doing high potential for 11KV 3 core cable how much leakage current will obtain?, what will be acceptance value?
How to calculate flow of water delivered by pump when pressure & size of pipe line is given
if 2 coil of 1000W connect in series and 200 v is applied across it . then what is the total power of coil when coil have only resistive load .
in ACB breaker requireding 3200Amps. buscoupler getting OFF mode and again it reset and getting normal position give me a required answer?
Can we use 230VAC, 63A MCB for 120VAC, 63A supplied heaters load?
When a single pase capacitor run motor- run on 230vac and Case(1)run with 8 Mfd 250 vac.capacitor , Case( 2) run with 8 Mfd 400vac capacitor. What is difference between both case regarding power ,efficiency etc?
Can any body tell me the different types of LT cables & their application.
What is the formula formula for Busbar sizing and what are the things to be consider for Busbar Calculation?
at work we have a 3 phase motor but on testing one phase isnt getting a reading. it runs 24 hours a day all week. stops and starts well no noise or heating. the phase isnt down to earth.is it just a bad meter reading or not? phases one and three came up with a resistance reading of 0.4 but phase 2 couldnt get anything shows up as open circuit.
what is mean by drives?
describe the Operation of induction generators from bus bars
why all the feeders are designed in a particular manner ... is there any reason for that???
How u can give the overload setting to any motor protection relay for a HT motors with formula and Example?
