Answer Posted / shenbagaraj.t
all vertical surfaces is shuttering and all horizontal
surfaces is centering.
| Is This Answer Correct ? | 2 Yes | 3 No |
Post New Answer View All Answers
How you read 5x3x1 #4 @ 20" 0/C in steel structure?
what might be the problem faced in the near future if the M-sand is used in the place of river sand during wall plastering? (As per IS)
What is the general specifications of a bituminous pavement road?
What is horizon or horizontal mining?
How many cum of 9.5mm stone in 1 ton ?
I have to design brick column and footing (note: without any reinforcement). Can somebody post me the design or suggest a book where i could possibly find the design? Plz help very urgent
what is the cost differene of a same structure when it is constructed with brick masonary, and when it is constructed with concrete as a frame structure.????????
I want to know how much the lapping length for the pilecap reinforcement.. we r using single pile cap which is 24mby54m and 2.5m depth.. total 91piles are supporting the pile cap.. how to do a steel reinforcement??
What is the l/d ratio of cantilever beam?
In foundation design, while we do the base pressure check, we normally check if the attained pressure value is less than the GROSS BEARING CAPACITY of the soil which is the sum of net bearing capacity of soil and the overburden pressure. Actually, the overburden pressure acts against the net bearing capacity of the soil and I feel that we are actually increasing the bearing capacity value and doing the check. I feel that this is NOT right. Please clarify on this.
Why was the empire state building made of steel?
in a building why we are using T beams? why can i adopt beam bottom & Top level as same as slab bottom & Top level?
Explain moment of inertia and its importance.
How much percentage of brick bats allowed in CD-75 bricks
What is the basic difference between OPC
