why we used for range in pnumatic 3-15 psi and current 4-20
ma?
- 11 Answers
- 39138 Views
- Jindal, I also Faced
- E-Mail Answers
Answer Posted / yashpal
i want to add just one thing that above mA there will be a
electromagnetic interference and signal may be distort due
to that.
| Is This Answer Correct ? | 1 Yes | 4 No |
Post New Answer View All Answers
What is difference between “Fault Tolerant” & “Fault avoidance” PLC? Application where these system s are used?
If relative y axis vibration sensor is by passed, and relative x axis and absolute sensor is left working. how much monitoring i would have risked?
How to convert milliampares into flow??
Draw bode plot of any transfer function. Why is plotting bode necessary?
Why MUX JB's are using only Temperature Element in Fundation field bus?
Why do we have earthing cable in branch cable and shield in the same cable?
which type of signal used in instrument?
Capacitance, resistance ( colour coding ), parallel & series circuits.
the whole paper was based on Transducers..questions like define repeatability, error,accuracy,precision..den there were many q. on the conversion of Pa to mmHg and other units.. also..der wer few Q. on some level sensors(with diagram)
What is zone,loop/fire alarm system?
how to turbine speed measurement?
what step is taken for ESD ( emergency shut down) in DCS REPLY to hashimka20009@gmail.com
can any send me a forbes marshall dtron 316 manual
What is Positive Calibration and Negative Calibration?
Calibration procedure for water rotameters
