Interested to Buy Any Domain ? << Click Here >> for more details...
how much steel is required foe following components..
footing-
plinth beam-
column-
beam-
slab-
- 1 Answers
- 6563 Views
- I also Faced
- E-Mail Answers
Answer Posted / sjtbehera
footing-2.5%
plinth-3%
column-2%
beam-2.5%
slab-3% of toal cum
| Is This Answer Correct ? | 3 Yes | 5 No |
Post New Answer View All Answers
IN Compression testing machine 1division =10KN ,then what is compressive strength of 100*100 mm cubes at a load of 320 KN
For Wet Mix Mecadam design what is Optimum moisture content
A 16 pile group, consisting of diameter concrete piles, were cast in situ in a clayey soil whose unconfined compressive strength is 1100 psf. Each pile is 60 ft long and the pile spacing is 2.5 times the pile diameter.The water table is at the ground surface and saturated unit weight of the clay is 118 lb/cu.ft. using a factor of safety 3 and a reduction factor =0.45, compute the allowable capacity of the piles acting as individuals
What is the difference between pvc,cpvc and upvc and where it is used as per their properties?????
What is the requirement for over all CG of DG from the foundation surface to absorb the vibration of heavy set.
primary treatment of sewagw consist of removal of floating materials removal of sand & grit removal of organic materials all above
Floor tile measurement? Wall to wall or skirting to skirting
What is the requirement for over all CG of DG from the foundation surface to absorb the vibration of heavy set.
residential buildings,mixing of concrete,structural,construction material,site handling.
what is the hanekom repairing material after concreting work
hi guys what happens if you are absent for a supplymentry exam?
cause of cylinder test failure
How to calculate sand , cement quantity for 23mm thk brick work(10x10)
suppose we have a tendency to make a hole on the surface of the simple supported beam, than where we goes to make it?
What is standard Sand? What is Regime condition? What do you mean by the core trench in Earthen Dasm? What is soundness test for cement? When negetive shear force takes place in a R.C.C member?
