In case of concrete cube test were all three molds are attached together do you cast your cubes simultaneously at the three molds every 50 mm or one after the other?
Answer Posted / sjtbehera
one after another is not a big thing. one mould cam complete
in 3 minutes. that is not big diffidence in strength
Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
16 questions out of 55 were from the book GUPTA N GUPTA OBJECTIVE of civil engineering. Total ques were 4 ques from hydraullics, 7 from BMC, 4 FROM SOM, 4 from soil mechanics, 6 from transportation, 5 from engineering drawing.
can you please tell me what the current rate of construction material and different construction labourers charge in bangalore ???
Suppose a new brick wall is being constructed,and the courses and not aligned horizontally,what negetives can it cause?
Can anybody explain with the help of sketeches that what are 2legged , four legged & 6legged stirrups and how to calculate cut length of diamond ring(stirrups)?
How much cements bag (or in KG) required for 1 Sq. M concrete, for M-30 grad concrete as per CPWD and where is thr proof on site
Rate analysis of Vitrified tile in cement mortor 1:3
Currently my house construction is going on but we just realized that the portico earth beam couldn't connect with the original earth because the beam rod not extended so Please advice
What out turn civil works
how can can column be corrected when the design is not safe ? is the increasing the clearcover a solution?
I want to know the relevant IS codes of practice which deals with different testings of cement-sand mortar (nominal mix)that is being normally used for brick work or plaster work in the construction work.
which are the Indian auther books for STONE COLUMN/GRANULAR PILES?
step by step procedure to find out the percentage of steel in coloum,beam,slab,footing in detailed
the distrubution system in water supplies is designed on the basis of avg daily demand peak hourly demand coincident of draft greater of B & C
On what basis we decide the formation level of the road? other then that of 50% Cutting and 50% Filling??
Basic questions of civil engineering