Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / sjtbehera
yes it is correct. it is a thumb rule for site execution.
but it vary on grade of concrete and steel. say in m20 grade
normally 41d for lap length
| Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
in plate load test what is the thickness of plate 20mm 5mm 50mm none
A doubly reinforced concrete beam is 25 cm wide and 50cm deep to the centre of tension reinforcement. The centre of compression is steel is 5cm from the compression edge. The areas of the compression and the tension steel are 10.16cm2 and 12.56 cm2 if m=18 and the bending moment at the section is 7,000,000 N-cm. Calculate the stress in concrete and steel.
Define What glue is least sticky?
How will you Engage Labours on Site?
List out some of the software program that can be useful for architect?
I want to know the relevant IS codes of practice which deals with different testings of cement-sand mortar (nominal mix)that is being normally used for brick work or plaster work in the construction work.
pls send me interview question paper with answer of EIL/AAI/UPSC/RPSC because i am doing prepration of compitation exam of UPSC for the Asst. Executive Engineer
if the nitrates more than 45mg/l in water lead to disease then what is it called
IS THERE ANY JOBS FOR THOSE WHO ARE IN FINAL YAER OF ENGINEERING(CIVIL) IN MUMBAI
how i convert mm into standard wire guage (SWG)no.
Explain what is the release of lien?
IS code for Rolling Margin of steel
How to identify the vitrified tile and ceramic tile by observation only after executing the job.
how we can find sieve #4 is 4.75mm?
what is Brick crushing strength(PSI)?
