Interested to Buy Any Domain ? << Click Here >> for more details...
What is the function of earthfault relay?
- 18 Answers
- 107801 Views
- MultiTech, Tech Mahindra, I also Faced
- E-Mail Answers
Answer Posted / soleha sarni
EFR is a relay which it sense fault between the phase and earth. the main function of the relay is to operate for the leakage currents to earth. there are two type of earth fault relays:
1. residual current earth fault relay
2. sensitive earth fault relay
| Is This Answer Correct ? | 4 Yes | 1 No |
Post New Answer View All Answers
how to calculation increase capacitor,increase power factor for three phase.
In the N-series schneider reclosers. What is the difference between current during fault time and current at tripping? This appears in the Event log in an event of a trip out.
Explain about Leakage Test.
Why space heater is required for each verical bus bar chamber? if one space heater is adequate or not for anti condensation?
A 230V dc shunt wound motor has an armature resistance of 0,15Ω.When operating on no load at 650 rev/min the armature current is 6A . The motor takes a full load current of 85A. Calculate the full load speed if the field flux is (i) maintained constant (ii)reduced by 0,03
stand by earth fault protection (51G) for transformer rating 2000 kVA,Dyn11,33/0.400 V. LV NCT ratio and necessary resistor and metrosil values how to calculate
how a flip flop can be used as a latch?
What do you mean by passive circuit elements and why these are called passive?
The slip during plugging operation is given by= A 1-s B 2+s C 1+s D 2-s
How many capacitors using in LT panel as per Govt rules?
How to calculate size of HT breaker with the help of Amp (current)? Please provide answers with examples.
i have seen one 8.4 MW synchronous motor in a plant located in bellary it is fixed with brushless rotary rectifier ,anybody can explain its start up principle
Dear all: Recently we got a question about Interface between PMS and SAP-PM.once we got a update message from PMS.we should set the deletional flag for functional location in SAP system.Is there any FM or BAPI to use?There are only functional location create and change provided by SAP. Best regards!
I have a relay contact rated at 220v dc which is supplied with a 24vdc from the panel,for it to trip the dampers(24vdc).What if the application of the relay changes so that it should work at its rated 220vdc then will it work at 24vdc supply given or any other consideration needs to be taken .....
DG cranking voltage?
