Interested to Buy Any Domain ? << Click Here >> for more details...
How to make position transmitter feedback reverse i.e at
valve close i want 20ma output and at full open 4ma.for the
NELES positioner,model:ND8261/TS1.
- 3 Answers
- 7052 Views
- I also Faced
- E-Mail Answers
Answer Posted / shabeerali
1. Reverse the potentiometer wire connection of position
transmitter.
2. Perform calibration. if required adjust zero and span .
then position transmitter gives reverse feed back
For direct feedback brown, red, orange.
for Reverse feedback orange, red, brown.
pls refer the manual
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
what is the responsibility of an instrument commissioning supervisor
How to calibrate the flow transmitter
Q- Control problem are mainly classified in _____ types. a-)4 b-)3 c-)6 d-)nono of these Few of them i know is 1- regulator type problem (eg- Air conditioner) 2- tracking problem (eg missile trcking problem) 3- sybernatics 4- optimal control problem
Tell about your IFFCO plant visit.
What are different types of orifice plates? State their uses.
What is motion balance principle?
What is profibus?
draw the block diagram of a level transmitter ?
TECHNICAL/ARTITUDE
Im having problems with interfase betwen SPI v7.0 and SPPID v5.05. Previous versions of Intools shoul be fixed with SPPIDproj.ocx file. It was necessary to replace this file with one that allows the connection between different versions of SPPID. It is necessary in the current version to do the same?Thanks
How you calibrate absolute pressure with the calibration range of 0 to 1000 0C Absolute. Please explain the procedure for calibration.
what happen if i increase height of displacer type LT.accuracy or sensitivity are affected.why?
What is loop1 and loop2 in MTS LT?
we are having yokogawa centum cs3000 dcs in our power plant. i need some of the operator guides NOT to appear in HIS0163 AND HIS 0162 but it shoul appear in HIS0164 HOW TO DO IT?
what are the steps I have to deal with?
