Answer Posted / vijendra joglekar
1 : Power Factor correction capacitors
2 : Improve the load percentage of particular equipment
avoid habbits of using lightly loaded machines which
results large power consumptions i.e.wastage of power .
3: Try using energy savings equipments example in fan
regulator (TRIAC) are used which results it dosent depends
upon the fan speed it will give the same amount of power at
all the times while in old regulator where rehostat are
used which results wastage of power.
Improving power factor is nothing but saving energy
consumptions!!!
| Is This Answer Correct ? | 8 Yes | 1 No |
Post New Answer View All Answers
What is phase cross over frequency?
which stabilizer is better ? AVR, Servo Stabilizer, Static stabilizer etc & why explain it
do any one help me to get "C" license,, i have doubts ,,, if mediators ter pls call me,, my no is 8056640042
How Can You Relate Power Engineering With Electrical Engineering?
Some times to change of DOR of a motor, interchange of R & B is not effected and RYB take same current, but interchange of R&Y is effected ie change the DOR. My doubt is what is the problem in motor and how it is happen.
How is the gain affected by the introduction of feedback in a control system.
What is the reason behind current flow(20 A) in amain earth cable of an SMDB? Is cuurent flow(45A etc) through a neutral cable acceptable?
why we use the 100% and 95% stator earth fault protection for the synchronus generator ?
why would amp draw on neutral wire be as much as amp draw on the hot leg.
what will happen if ac and dc supplies given
What is the effect of positive feedback on the stability of the systems?
whether starting current is limited to rated current of motor through soft starting or it exceeds the rated current?
The slip during plugging operation is given by= A 1-s B 2+s C 1+s D 2-s
What is the breaking capacity of transformer and how can we calculate the breaking capacity of tranformer
Hi Everyone ! My Name is Hakim ullah khan please i need formula of Cable Rating because i want to calculate by self without check any Table Chart... Thank you.....
