Interested to Buy Any Domain ? << Click Here >> for more details...
please tell me how to
convert double acting ytc
positioner yt-1200 into
single acting ytc
positioner ?
- 1 Answers
- 4009 Views
- I also Faced
- E-Mail Answers
Answer Posted / carl_ellis
Many manufacturers make all positioners a double acting
positioner and install a plug in the 2nd port and call the
model with the plugged 2nd port a single acting positioner.
No guarantee that all manufacturers do so, but it's true for
some of them.
You have a double action positioner - install a plug in the
2nd output port, plumb it to air and an actuator, give it
try as a single acting positioner and see if it works.
What do you have to lose?
Carl Ellis
Measure First
| Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
Hi Friends i am going to write BARC written test by this month 20th (20-5-2008). So please if any body knows the details about this or having previous question papers pls mail me to kkumarei@gmail.com. For Suggestions give one message to 9962122264
What are the uses of orifice plates?
where proximity sensor installed on tank in loading arm application
How to calibrate the flow transmitter
How hart protocol can be connected with control valves?
Specify for Cables - Flame Retardant and Fire Resistant?
sir ,iam in dem urgent need of HPCL Paper of Instrumentation Branch plz send me at your earliest convenience at ujjwal_sharma1983@yahoo.com
Why 4-20 amps is being used in instruments? Why cant we use any other range instead of 4-20 amps? Why only 4 amps is taken as lower limit and why 20 amps is taken as the higher limit?
Explain why use mmwc unit?
the pump holds on run indication into the dcs and filed local control panel remote push button condition operaton wrong like when the push button pushing conditions the pump is off and the push button release condition the pump is on totally opposite condition . And control room inside give the stop command into dcs just 1secon relay engage and again normal condition. How can I slove
What is the working principle of the magnetic meter?
Why upper weighing limit of electronics balance is 90% of the total weighing capacity?
Drum level tx with GP4 with zero elevation:7300mmh20 on HP and 8050mmh2o on LP as range but on commissioning the tx readiing is max,Why this reading?
How to fix back the valve actuator stem
WHAT IS THE CAM POSITION IN CONTROL VALVE POSITIONER ? WHY IT IS USED?
