if u have to run a 300kw moter then what is ur choice HT or
LT switchgear & explain why?
- 3 Answers
- 7360 Views
- Aditya Birla, I also Faced
- E-Mail Answers
Answer Posted / sadam hussain gaad
Depends upon application.
if all other motors are operated on HT/LT then 300 KW motor
should be opertaed on HT/LT respectively.
If your generation is HT and you want operate on LT then
you have to install VCB, Transformer, ACB and size of cable
will be more as compared to HT but less insulation will be
required.
If you want to operate 300 KW on HT then no need of
transformer,ACB, only XLPE cable will be used.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
Why Ac Systems Are Preferred Over Dc Systems?
Why PS class CT is always preferred for Differential protection?
List the characteristics of filter?
What is float cum boost charging system?
Is there any problem about which the drive (inverter) doesn't show/display the alarm and/or fault but instead of this , it doesn't work ? I want to know that could there be any kind of problem in the drive when the drive doesn't display the alarm and/or fault ?
Dear sir, my knowledge about cable size determination is limited. Though I read examples I could not calculate the Cable size required for electric driven pump 40 KW, 380 Volt, 50 HZ, 50 meter from transformer and it is three phase star delta starting. Please help as there is no one in my surroundings to help.
HAI SENT HPCL APTITUDE QUESTION PAPER, MY EMAIL ID IS angus_eee04@rediffmail.com,angus_eee04@yahoo.com
What is the difference between electronic regulator and ordinary rheostat regulator for fans?
PLEASE INFORM ABOUT THE IDEAL TEST RESULTS OF MAGNETIC BALANCE TEST OF TRANSFORMER 33/11 kv DELTA-STAR T/F
What is conventional thermal current (Ith)
Define step response?
1 “earthing” for bonding of equipment and circuits to common plant earth electrode potential, 2 “protective earthing (PE)” when this bonding is required for personal safety provisions 3 “grounding” for interference suppressing bonding of screens, sys-tems with ground level 4. low-impedance earthing ? 5.primary earthing system and secondary earthing system what is that? 6.earthing electrode or mesh net earthing electrode ? very confusing , simple but very informative help required ? i will be very very thankful to you guys.
why can the rotor of 3 phase slip ring induction motor not be a 2 phase rotor?
I have a CT meter with ratio 60/5. The meter reading of previous month was 3290.49 and that of current month was 3797.26. How many chargeable units as per normal meter should be my reading.
can someone explain that how the speed of the protection system affects the fault level calculation?
