Interested to Buy Any Domain ? << Click Here >> for more details...
In an LT pole, the line voltage is 415V. How is it
converted to 230V into the house via the service cable?
- 10 Answers
- 18204 Views
- I also Faced
- E-Mail Answers
Answer Posted / shahzad
line voltage=the voltage between two phases=415v
phase to neutral voltage=line voltage/1.732=415/1.732=239.6v
| Is This Answer Correct ? | 4 Yes | 0 No |
Post New Answer View All Answers
Why colled 440V to 3-phase supply.
What is meant by full pitched winding?
I have a drawing of a wound rotor induction motor for a crane. This crane motor has 5 forward speeds & 5 reverse speed implemented of course with different amount of resistance for each speed setting selected. What has got me scratching around is the fact that 8 of the 10 speed selections switch in uneven (unbalanced) amounts of resistances on each of the 3 connections to the motor's rotor.Can this be possible? I would have assumed this would produce unbalanced rotor currents and therefore vibration in the motor. I would greatly appreciate anyone's comments on this. Many thanks, Confused.
Is it possible to obtain 480v or 550v in single phase output by giving the input to 230v to a single phase torodial type transformer without using a stepup transformer?
What is the Load Capacity of Panther conductor (0.2) and dog conductor (0.2)
Good morning: I'm looking for some informations about the OLTC or the LTC: I wont to know what the function of the tie-resistor in during the operation of reversing/coarse operation Cordially
how cables go in and come out for distribution from the feeder pillar box?
we all know voltage is a force(emf), and the force always devides if 2 or more than2 loads are there but why does the voltage remains same is parallel, it must devide na ???
Draw torque - speed curve and load curve of induction motor? mark operating point ?
Dear sirs, pls check this 4-20ma to RS485 module datasheet,pls guve me some suggestions. http://www.szsunyuan.com/sy/pro_more.asp?Productid=539 Thanks. E-mail:yunianjiang99@gmail.com
what happen if drive input fail momentry at 48.5 HZ frequency?
WHAT IS DEGREE OF COMPOUNDING IN D.C MACHINE MEANS? HOW TO READ THE OPERATING CHART FOR ANY ELECTRICAL MACHINES?
How to Calculate KA Rating of Main LT Panel
WHY L-G FAULT IS MORE SEVERE IN TERMS OF RRRV?
What is the basis for framing the rules of block diagram reduction technique?
