Answer Posted / simon
5000 v on 140 to 160 R.P.M.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
how to calculate distance between busbar supporters for LT panel, what are the factors influencing in this design
How phase displacement change in the over current relay coils.
If not into production, how far did you follow the design and why did not you see it into production?
Why the power generated in dams is complex power? Why the generators in dams cannot produce Real power directly (i.e power which has zero reactive part)?
i have a 4 Mva transformer 34.5 kv / 480-277 v and i used 2 parallel 3200 amp bus duct for the secondary feeder using 3 ply of bus bar ( 3/8" x 5" ) as a common where the flexible link terminated and 6300 amps breaker for the main, the lower bus duct reaches 70 degrees and the upper bus duct reaches 55 degrees when i used thermal scanner. why the temperature is not balance when the load reaches 3600 amps.
how much leakage current is allowed in MC61A L&T make relay?
What is milivolt dop test in Busducts? What is its significance & procedure to do the test?
State the methods of improving power factor?
what is the reason for indication of light in the earth lamps of main switchboard.if there is an earth why does one lamp get dim and the other two bright.
types of central Air conditioner plant?
What is the method of estamating of cable, CB,MCB ?
how to calculate single phase motor efficiency ?
how electrical earthing maintenance done in industry?
Why Stabilising Resistor used in REF circuit ?
why electronic instruments is more favorable than electrical?
