Interested to Buy Any Domain ? << Click Here >> for more details...
How to take Transformer oil Break down voltage test?
- 9 Answers
- 30100 Views
- I also Faced
- E-Mail Answers
Answer Posted / v.b.vijay anand
At first thing you maintain the electrical norms..To Take one sample from top of Transformer and one from the
bottom of transformer.
On before take oil samples you should confirm the moisture particles removed are not..
And then removed the air boubles in that vessel between the electrode...
The BDV of oil should withstood min 50 KV...
The gap between the test sample is 2.5mm maintained..
Voltage should be gradually increased from 0.
You will wait min 30min then only you will get good result..
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
What Is Sampling?
what is mean by PIR in circuitbreaker and give me detail of that?
2 v/500amp/hr to 1.80vpc at 20 degree celsious 2v/5ooamp/hr to 1.75 vpc at 77degree farren .this is the capacity of a battery .what is the meaning of this . can i get a detailed explenation
y we use neutral,all r told its used to for closed path..k its a just used to closed path,in a transmission line y we put same conductor used n both phase and neutral..if we use less than phase conductor in neutral mean we ll reduce cost its right r wrong..if we use mean any problem occur in transmission line..
what is meant by CT`s saturation ? Can we use Metering CT`s with Protetection CT`s ?
what the principle of sincroscope?how it works?when it needed?
What is Surge Capacitor? Why it is use in Generator Circuit Breaker?
how to choose cable size with respect to load? how to convert cable size in mm2 to sq.mm?
Draw the vector diagramme for Asynchronous Induction Generator at noload,half load and fullload.
How to calculate the phase to phase clearness of HT /// LT bus bar?????
Is a contactor (or master relay) required between incoming lines and a VFD? The question goes to safety. If a contactor were used before the VFD and an e-stop engaged then the motor will coast to a stop (i.e. VFD loses power) instead of stopping much faster if the VFD braking fucntion were used. It would make more sense to keep power on the VFD.
what are the analog quality input for protection function?what are minimum reqiments?
trasnfarmaer core make
The moisture in air will condense at
What is slip in an induction motor?
