Interested to Buy Any Domain ? << Click Here >> for more details...
How calculate cable size & voltage drop for the following
requirement
connected load 150 KW distance cable length 1000 M voltage 3
phase 415 v.
- 1 Answers
- 3930 Views
- I also Faced
- E-Mail Answers
Answer Posted / kanishka verma
you have to use 3 core multistrand copper wire of 240 mmsq
with (silver coated),
amps= 150*1000/415*1.73
find the current capacity by cable size by chart,click the
link down here....
(http://www.miccomcables.com/Webrochure/Current%20Carrying%20Capacities%20&%20Other%20Technical%20Tables.pdf)
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
how to design step down 12 V, 1mA small transformer from 220 V AC? Because according to VI relation and power transfer it results bulky...
In single phase ac ups supply when current is measured with tong tester neutral current is found more than phase current.What is the reason?
if in 3-phase system voltage=440V,frequency=60Hz, current=400A. then if it is single phase then current=? and if it is single phasing then current=?
how many joints are allowed in underground HT cable of 1 KM
How to calculate size of HT breaker with the help of Amp (current)? Please provide answers with examples.
In layman terms, what is the difference of Dielectric strength and dielectric constant when speaking of an insulating oil
all the technical question with answers pleas send your email id ramar_eee@yahoo.com
what is the use of Auto re-closer?
Why insulation level follows this order? transformer < bus bar < circuit breaker & Isolator < transmission line.
Is any AC drive(VFD) had a feature of DC injection braking? if available please mention the detail. i.e drive can supply braking torque when the motor in idle state.
what is the differebt between ac and dc fuse?
what is relation between ct and pt ratio with multiplication factor of a energy meter? is there any other factor on which multification factor depend?
What is center gravity load in substation?
HOW TO CALCULATE HV TEST VOLTAGE FOR ELECTRICAL EQPT.
why is control bus bi-directional?
