Interested to Buy Any Domain ? << Click Here >> for more details...
we touch other end of the tester supply, why do not get
shock?
- 7 Answers
- 15550 Views
- L&T, I also Faced
- E-Mail Answers
Answer Posted / shashidhara
Rating of voltage is 230V only. The current is low enough not to hurt us and just enough to light up the bulb. But, the same tester can't be used to check higher voltages. We use only the voltmeters and other devices to check supply in higher voltages. If we use tester, we get shock at those high voltages.
| Is This Answer Correct ? | 2 Yes | 4 No |
Post New Answer View All Answers
What is the difference between acs 550 & acs 850
Determine the BTU size of an aircon for 20 sq metre room
at which voltage level arcing ground is occurs ??????????
What is the current carrying capacity of 0SWG,3SWG,10 & 12 SWG solid bare overhead copper conductors?
What is different between resistance grounding system and resistance earthing system?
Make a list observation on Transformer?
upto how much low RPM we will run the commercial motor which is run through VFD without any problem occurs in motor.Motor rating Duty is S1 & RPM is 1400.
How would you calculate power loss in a resistor?
what is the size of cable for 15kw motor and 85 meter cable length using with vfd
In a large office how do we calculate required number of light fittings, assuming fittings are 4x18W or 2x36W fluorescent fitting ?
delta motor winding resistance I take normally single winding is 2.5, which value is came delta connection ie RY ?
please write motor, transformer, Generator setting, fault level calculation of Tr.etc
What is the equivalent circuit of a transformer and its vector diagram?
what is W.T?specify the acceptable range?
Dry type transformers
