Interested to Buy Any Domain ? << Click Here >> for more details...
Why should not we run the IM in low voltage, if runs means
what will happen?(for example instead of 400V we give 250V
supply)
- 2 Answers
- 4050 Views
- I also Faced
- E-Mail Answers
Answer Posted / vishv shah
sry...for that wrong ans.......for
low voltage(1 phase - 230 volt)
operation! IM needs some mechanical
machine to start the motor but while
in high voltage(3 phase - 440 volt)
their is no any requirement like in
low voltage.....so........because
in high voltage rmf is generate to
start the motor
| Is This Answer Correct ? | 1 Yes | 1 No |
Post New Answer View All Answers
why Lightning arrestor are made by 2 seperate stack of inslutor but why cvt are in single stack of insulator.
Where servomechanism is used?
how to check regenerative load in drived motor
What is the difference between single core 2 wire and single core 3 wire system? Which application we are using this? and for What purpose we are using this?
In a carnot engine with an efficiency of 40%, the heat rejected to the sink at 27 C is 60 kJ, then the heat supplied in kJ to the engine by the sources is
why tertiary winding is used in transformer with diagram?
why we use sinosidal voltage / current instead of others in system?
Explain Even and Odd signals?
what is v/f control in VFD?
State any two nuclear power stations in India, with their generating capacity.
Percentage losses in power generation?
explain PV modules in solar energy generation.
What is relation between mu(nought) and epsilon(nought)?
Difference between RCCB, RCBO and ELMCB.
what is the standard values(Megger test) of resistances between L&N,L&E and N&E for a system on IEE regulations?
