Interested to Buy Any Domain ? << Click Here >> for more details...
what is advantage of using star to delta in place of dol
starter
- 4 Answers
- 6870 Views
- I also Faced
- E-Mail Answers
Answer Posted / liliosa b
it is cheaper compared to other reduced voltage methods
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
How to do cable sizing calculation for 750 A Neutral Earthing resistor for 33kv. the 33kv cable going to swbd. is 630mm2 3 runs.
difference between main metering kiosk and check metering kiosk
what is the need to express current and voltage in rms value? rms value is also called as effective value,what is effective value?
Can you explain about TEE protection scheme?
What are the types of control system?
What is difference between unity power factor wattmeter and upper power factor wattmeter? In short circuit test of transformer the wattmeter used is unity power factor type or upper power factor type wattmeter?
1. A 380 / 220 V r.m.s. 3-phase 4-wire circuit carries loads of 8 + j8.1 ohm; 4 + j4.1 ohm; and 2 +j2.1 ohmin the three phases respectively. The length of the circuit is 100 m, and the resistivity of the phase conductors is 0.0005 Ω/m. The neutral conductor is of the same size as the phase conductors. a) Select a reference angle 0for the first phase. Then write down the three phase voltages in both polar format and complex number format. b) Make appropriate assumptions, and take temperature effects on resistance is insignificant. Calculate the currents in the three phases. (Note: Determine conductor resistance, and apply Kirchhoff’s Voltage Law) Based on the result, suggest a main switch rating for the circuit. c) Show your preferred direction of neutral current in a diagram, and then determine its value. (Note: Apply superposition principle, and Kirchhoff’s Current Law) Use its magnitude to show that in this circuit, the unbalanced load may increase the voltage drop in some of the phases. (Note: Also observe the common volt drip in neutral) State your assumptions, if there are any. d) Suddenly the neutral wire of the circuit is broken. Estimate the new currents in the first phase, i.e. Phase L1. State your assumptions, if there are any.
what is deffrence between squirral cage and wound rotor in IM?
any one guide me to reduce the power factor of diesel Generator from 0.97 Leg to 0.8 Leg.with out any change in my load.
As you achieve greater success with the company after some years, Will you like to be a share holder in our company?
What is the minimum underground tank size capacity considered for firefighting purpose?
what is acceptable leakage current for 33kv cable while doing high voltage test for cable? how to calaulate the leakage current for 33kv or any rated cable?
What is resistance reading of earth copper rod with grid and without grid?
how we can find of current direction(supply comming/out going direction) when a transmission line passing through sides.
what does mean of RCT and STR in diffrential CT?
