if it is possible for the air conditioner to maintain the
temperature of 20 degree Celsius when the atmospheric
temperature is 10 degree celsius
Answer Posted / lakshmi niwas pathak
Few of the simulations result in less than 2 °C of
warming—near the low end of ... This pattern (statisticians
call it a "right-skewed distribution") suggests that if ...
system: the change in surface air temperature (ΔTs)
following a unit change in ..... central value C indicates
the maximum likelihood estimate in degrees Celsius and ...
Is This Answer Correct ? | 1 Yes | 2 No |
Post New Answer View All Answers
Give an introduction to bourden pressure gauge?
What will you check if one cylinder of your engine is not like the others?
why we transfer FA(full arc) to PA(partial arc) in steam turbine at specified load?
What is higher IMP or BHR
If you are scientist to b e and you wish to develop a self-generating power appliances, what would b e the ranking of importance to apply your concept of creating energy using alternator: 1. Washing Machine 2. Motor Water Pump 3. Electric Fan 4. Electric Stove 5. Flat Iron – Which one will b e your foremost and the least at the rank of 1 to 5? Why is that so? Defend your answer.
Please brief me about Ball-screw.
what is the difference between type -a and type -b iron > The chemical compostion is given here under and also guide us the effect of Ni;Cr;Mo in the iron; name and use of these two types of iron Type a Type b %C :3.15 2.65 %Mn:0.41 0.52 %Si:1.72 1.60 %S :0.090 0.082 %P: 0.215 0.204 %Ni: 0.40 Traces %Cr : 0.49 Traces %Mo : Traces Traces
plz send me paper of mppgcl 2008 or experience posted by any candidate
what is an intensifier?
what is procedure of measuring operating length of mechanical seal . (in case of centrifugal pump)
how control valve works? process line pressure is 50kg/cm2g and instrument air pressure is about 4 kg/cm2g.
i want to know how a dg set run/works and what is strock and what difference in between two and four strock engine.
Discuss venturimeter?
Can an airplane fly without a tail?
any body hv a experience of L&T pget interview for mechanical thn send me question and experience to me as i hv interview on 8 th may so send me as soon as posssible on my mail id nilesh.spy2000@gmail.com