Interested to Buy Any Domain ? << Click Here >> for more details...
what happen if i install my pressure transmitter below the elevation of pipe in natural gas service. Also support your answer
- 3 Answers
- 9360 Views
- C2C, I also Faced
- E-Mail Answers
Answer Posted / narayan
it will not give correct pressure, since natural gas condense in the lower side, actual pressure will be added with this head pressure of liquid, hence it will not give the actual pressure of gas
so transmitter should be installed above the pipe line, to measure exact pressure of NG
| Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
how works encoder in plc
Why ac supply load cell is used? Can we use the dc supply load cell?
A DP transmitter is used to measure the level of an open tank. The drain line of the tank is connected to a control valve, and is configured as, if the level of the tank is 90% the valve should get open 10%. And if the tank level is 10%, the valve should get open 90%. Draw wiring diagram and explain how to configure DP transmitter and control valve using HART communicator. If the span error at output is 1%, what will be the %opening of the control valve at 60% level of the tank?
We Have Two Field bus Pressure Transmitters of Different Sensor Range (I.E One is of Lower range and Another is of Higher Range).Is same Process Line. My Question is Can i provide Saturation Limit to my field Bus Transmitter as We can provide Saturation current limit to HART Instruments. As During Low Pressure Both Working OK ,But During High Pressure, transmitter with Lower sensor range Goes to Fault mode as Beyond its Sensor Limit it can Measure, So may I provide Saturation point Some where to Suppress This Fault during High Pressure.
To become an Instrument DESIGN engineer, is there any softwares or training to become Instrument Design engineer, plz suggest me, Iam very much interested in designing.
What is profibus?
plz you help about Que paper of mahagenco previous your,any model paper relad to it{maharastra power genration}
How it the difference between force balance system and dispalacement balance system?
when a magnet is heated?
Q1]IF THE RANGE FOR FLOW IS -35 TO 125 WHAT WILL BE THE SPAN FOR ABSOLUTE AND FOR NORMAL? Q2]HOW TO CALIBRATE CAPILLARY TYPE LT? Q3]HOW MANY ERROR CALCULATIONS ARE THERE USED IN PROCESS INDUSTRIES? Q4]HOW TO CALIBRATE TEMPERATURE TRANSMITTER? Q5] HOW TO CALIBRATE LEVEL TROLL AND HOW TO CONNECT? Q6]PLEASE TELL ME THE BASIC FOR INSTRUMENTATION WHICH IS APPLIED FOR CALIBRATION AND FOR ALL? PLEASE MAIL THE ANSWER TO honest_yes@yahoo.in
Why even multiple power supplu r used in instrumentation system?
what are the selections available in configuring a burnout protection of a controller? thanks
NSV type probe stands for
Q- Control problem are mainly classified in _____ types. a-)4 b-)3 c-)6 d-)nono of these Few of them i know is 1- regulator type problem (eg- Air conditioner) 2- tracking problem (eg missile trcking problem) 3- sybernatics 4- optimal control problem
Difference between dcs and plc including date processing and architecture.
