Interested to Buy Any Domain ? << Click Here >> for more details...
my question is that....few days ago i had installed a three
phase motor starter for an electric saw.the motor will run
and make the hydraulic pressure which will be goes to
pressure cylender by up and down lever.two number of
limitswitches are also installed on cylinder for safety of
motor.now when the arm of cylinder reaches to the upper or
lower limit it will cut the motor's line.and motor will be
stop.now wana know that what will i do that motor runs
continue after the limitswitch cut it down but it shold not
be made any pressure.pls answer me in brief.
- 3 Answers
- 4799 Views
- I also Faced
- E-Mail Answers
Answer Posted / pillay
The motor is driving a hydraulic pump.Install a relief valve
set at the correct pressure in your hyd system where the pump
can perform its task but when the piston reaches the top the
pressure build up will be too high and the excess pressure is
released through the valve, the limit switches wont be
necessary any more.the pump will be running all the time.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
which is better to use svc or synchronous condenser why ?
dg started in plc mode and load taken later one battery terminal connection will be disconnected by loose connection what will happen for dg and shall we connect battery terminals while dg in load time?
What do you mean by turns ratio of instrument transformer?
How to know of any cable size if there are not written on cabl?
What do you mean by an instrument transformer?
what is the difference between "Rotary bypass isolation switch and Normal bypass switch" pls share indepth techs?
what is the purpose of silicon dropper used in battery charger?
What is meant by Im=30mA@Vk/2. How to know the kee point voltage for CT design
Define super node?
is it necessary to earth the rmu before cutting off the transformer winding?if yes why?
explain PV modules in solar energy generation.
Can we use 230VAC, 63A MCB for 120VAC, 63A supplied heaters load?
What is the difference between a Root Locus plot and a Bode plot?
LET ME NOW MORE ABOUT icu and ics for circuit breaker. how we calculate the rating of circuit breaker and i c u and ics values
What is different bewteen low or high impedance busbar protection scheme
