Interested to Buy Any Domain ? << Click Here >> for more details...
If any control valve create hunting problem, what is the
possible reason and solution?
- 6 Answers
- 20933 Views
- I also Faced
- E-Mail Answers
Answer Posted / muhammad arsalan afzal
1=First of all check the feedback link of positioner mostly
such type of problem occur due to feedback link looseness.
2=Gain of the controller is too high you have to adjust it.
3=Gland packing is too tight slightly lose the gland pusher's
screws.
| Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
what are the use of belew gear in general ??
what would be the minimum flow rate that we can measure on rotameter..?
I am teja. I am studying Msc(tech) Electronics and Instrumentation (3years course) in Andhra university. But my course is not recognised by UGC and AICTE. Please tell me the job opportunities after this course. And i fineshed PLC course in IGIAT ,Vizag.Also complted my short term coure in SCADA, Seimans WinCC in ATI,Hyd.After Msc can i join Mtech for good job? or phd. How i can get good job in INdustrial Automation Side. Please give replay.Because this is my life matter.
In bently nevada vibration monitoring system,what is the reason to maintain the Resistance of the probe + extension cable equal to 95 ohm? If possible explain the basic principle of measurement with detail electronic circuits.
components of control circuit belongs to control valve
how to relay switch sense the fault?
In power plant to measure vibration of a turbine we install sensors. Before install this sensor we have to set gap voltage. What is meant by gap voltage and its use?
what is the diffrence between pressure safety valve & pressure relief valve....pls
What are the different types of thermistors used in industries? How to the operation of typical thermistor?
How hart protocol can be connected with control valves?
What is the diffrence between ff tx and non ff tx
can anyone tel the syllabus or previous year question paper for BHAVINI(EIE)2014.
What is the exact differences between HART,FOUNDATION FIELDBUS,PROFIBUS?
i want to know the interview format fot gail, instrumentation. pls answer me in habib.sami1003@gmail.com
Why plc require in analog input 4-20amp & 0-10 volt?
