Interested to Buy Any Domain ? << Click Here >> for more details...
Why we should use delta connection in primary and star
connection in an distribution transformer, which converts
400v a.c. voltage to 33kv.
- 15 Answers
- 49249 Views
- ABC, Kirloskar, Sify, I also Faced
- E-Mail Answers
Answer Posted / gangadhar
Primary function of Distribution Transformer is to step-
down 33kv into 440v..while designing the transformer we
have to consider conductor size also...in delta side line
current=1.732 times phase current and in star side phase
current=line current...as we know current is directly
proportional to cross-section of the conductor..keeping in
mind about the cost factor of conductor on load side they
prefer star connection on load side..Guys i tried to
explain in different way..i agree with above answers
also
| Is This Answer Correct ? | 4 Yes | 1 No |
Post New Answer View All Answers
How many devices can be connected in one zone of FACP
what is the use of permanent magnet generator in exciter
In MEP Services what are parts of STP and what are there function?
What is the difference between rated and per unit in transformer?
what are types of encoder
3- What is the target from Zero Impedance, Single Phase Imp., S/C Imp. and magnetic balance tests?
What is the Surge for 1.1 Phase Induction Motor(For Eg.1Hp) 2.3 Phase Induction Motor(For Eg.1Hp) 3.AirConditioner(For Eg 1Ton) 4.Refrigerator(For Eg 180Ltr or 160kW) 5.Induction Cooker 4. Ceiling Fan
what is the purpose of bypass mode in energy lighting transformer?
The 3 phase 400 hp 440 volt slip ring induction motor do not take one phase amps why ? The motor is running good condition
how to calculate current and voltage in a same circuit?
In Generator How suction compression power and exhaust works ?
Please clarify, 1. Is it required to lay two runs of GI wire along with Armoured LT cable if it is laid between one big mains (63Amps TPN SDF) to small main (32A TPN SDF) with proper glanding termination? 2. If the armoured cable with proper glanding is laid from DB to CNC machine, is it required to run two runs of body earthing to the Machine from DB? 3.If the armoured cable with proper glanding is laid from Substation to Hangar, distance is approx. 100 mtrs, is it required to do earthing at shop area though the primary termination at substation is earthed through gland.
DG Earth Value?
What does the term “voltage regulation” means?
how we can come to know that motor winding resistance which showing by DMM is right or wrong???is there any chart or something that we will compare & check???
