Interested to Buy Any Domain ? << Click Here >> for more details...
how to calculate cable size, olr rating, contactor rating
and mccb rating,to below given details three phase motor
75 kw,415 v,.85 pf,50 hz?
- 5 Answers
- 73905 Views
- Cabin Crew, Essar, I also Faced
- E-Mail Answers
Answer Posted / pvr.parthasarathi
75 Kw motor takes 134 amps full load current. But for
selecting its Cable, Contactor, OLR and MCCB, we have to
consider many other factors such as need of its operation.
Place of the Motor Control Centre and possibility of laying
the cable Wheter inside the duct, underground or in the
air. For selection of the Contactor enclosure of the
panel, its environments etc are to be taken into
consideration. So giving answer at a stretch basing on
some thumb rule is not technically qualified.
Other particulars are required.
| Is This Answer Correct ? | 19 Yes | 5 No |
Post New Answer View All Answers
why the frequency and voltage in india is 230v and 50HZ. when compared to USA say 110v and 60 HZ.
15hp motor wound by 0.9mm & 0.95mm magnet wire. at no load test it draw 4.2A current. Another motor with same condition draw 9.2A current. How can that occur? pls help
what is the step by step formula for calculating bus bar phase and neutral size of a panel board.suppose the incomer of panel board is 100A..???step by step answer please
Why generation voltage in thermal power plant is between 11kv to 33kv?
What is meant by reverse polarity and how it can be fixed?
Hi friends, i m electrical engineer i want a cdr for migration purpose so anybody have information about this then send me on jayesh_ee88@yahoo.com.please try to me
while doing high potential for 11KV 3 core cable how much leakage current will obtain?, what will be acceptance value?
what is the meaning of 0.5ohm Resistance
I have motor 1500 HP and , 4160 V , 60 HZ , then i need the rating of transformer which can feed that motor ??
volts=230 c=10mf a=??
why is control bus bi-directional?
What is ramp signal?
why the neutral line is not giving shock to us if we touch it ?
how much GROUND & NEUTRAL VOLT maintain in data center.
Sir, My doubt on cable sizing calculation, Load:74 KW calculated cable 1 run 50mm2. Now client asking us to reduce cable size by increasing runs. Sir, My question now when my mind strikes with 2 options 1) Divide load 74/2 = 36 and calculate cable for 36+36 making it 2 runs or 2) Simply i can divide 50mm2 /2 ie. 2 runs of 25mm2 Please suggest me sir
