what is the function of potential transformer in s/s
Answer Posted / dhanunjaya hk
The PT function in substation it is used metering & protection purpose. Protection in line and bus,over voltage protection & under voltage protection. PT used up to 11kv to 110 kv. & above 110 kv we used CVT.
Is This Answer Correct ? | 9 Yes | 1 No |
Post New Answer View All Answers
what is kvarh? Please define it With calculation General motors ?
star delta starter contorl circuit... drawing..
what is the use of the puls transformer in UPS & how it works???????????
in HT service 3ph 4 wire service Y-phase voltage shows zero . whether it is meter fault? or what be the reason ? if y-ph voltage zero ,can current is recorded? reasons for failure?
why we are not giving the zone 1 trip command to the master trip relay
What are the differences between single phase and three phase?
i am going to attaned the engineer (disign)iterview at HAL please give me duid line
What is meant by impedance? difference between high & low impedance ?
What is mean by hot and cold loop testing? What is the difference between them?
What is resolution of a measurement?
hi friend i am going too attend for hpcl in this month please help me by sending written test question papers i am in the stream of E.E.E
What are the common sources of energy?
How to calculate flow of water delivered by pump when pressure & size of pipe line is given
Explain about Leakage Test.
What is lighting kitts.