Interested to Buy Any Domain ? << Click Here >> for more details...
What is cold junction compensation in thermocouples? How is
it achieved?
- 4 Answers
- 11603 Views
- Honeywell, I also Faced
- E-Mail Answers
Answer Posted / vinoth.s
TC works on the principle of SEEBACK's Effect, which states
the the temperature difference is directly proportional to
induced emf, when two dissimilar metals are twisted together
and heated at end.
its equation states,
hot junction - cold junction = induced emf.
its means hot junction is the temperature measured..
cold junction means the ambient temperature unlessly
considering the compensation. we have keep the cold junction
as constant by giving a constant hot source or ice bath. so
that its easy to find the hot junction values.
| Is This Answer Correct ? | 4 Yes | 0 No |
Post New Answer View All Answers
Describe how to use megger to measure the earth resistance and insulation resistance
We Have Two Field bus Pressure Transmitters of Different Sensor Range (I.E One is of Lower range and Another is of Higher Range).Is same Process Line. My Question is Can i provide Saturation Limit to my field Bus Transmitter as We can provide Saturation current limit to HART Instruments. As During Low Pressure Both Working OK ,But During High Pressure, transmitter with Lower sensor range Goes to Fault mode as Beyond its Sensor Limit it can Measure, So may I provide Saturation point Some where to Suppress This Fault during High Pressure.
how to calibrate electro pneumatic positioner 8013 mil controls ltd ?gsr
TEMPERATURE VARIATION FOR FREQUENTLY.
How to calibrate level transmitter with use of HART?
Instrumentation symbols interpration, P& ID, Logic diagram analysis, Electrical drawing analysis.
WHAT IS THE DIFF. BETWEEN SKIN TEMPERATURE AND PASSES TEMPERATURE..?
What is force balance principle?
plz send me general of ongc
what are the values of fuel flow rate in various places in boiler.
the 3 most common transmitter protocol being in refinery or qatar gas and aramco.
Gas equation
why micro controller 8051/52's clock frequency is internally divide by 12 ?? and why it is further divide by 32 in UART serial communication ??
Square root calculation for dp flow transmitter?
How you calibrate absolute pressure with the calibration range of 0 to 1000 0C Absolute. Please explain the procedure for calibration.
