Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / parth desai
Steps as below :
(a)Set desire pressure.i.e for e.g 4 kg (bar)
(b)Keep multimeter's wire on 1 & 3 point of coil.
(c)Move nob with 5 num.LaN key in clockwise or
anriclockwise direction till you will get continutity.
(d) as you will get continutiy @ 4 bar ur input in PLC will
cut. now tight grub screw of pressure switch.now increase
pressure from 4 bar so you will get i/p on plc.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
why we us isolation barrier in hazardous area how it works to protect the area and please clarify its current flow.
sir i m preparing for BARC but i am not getting any papers to prepare for this exam so please send me some sample papers to my i.d for the preparation of barc.
What is super thermocoupal?
what is the responsibility of an instrument commissioning supervisor
OBJECTIVE TYPE QUESTIONS OF ANALYTICAL INSTRUMENTATION
what is the difference between attemperator and desuperheater ?
For crude application in floating roof tank, how to calibrate a DP Transmitter? How is the floating roof weight considered?
For crude application in floating roof tank, how to calibrate a DP Transmitter? How is the floating roof weight considered?
the pump holds on run indication into the dcs and filed local control panel remote push button condition operaton wrong like when the push button pushing conditions the pump is off and the push button release condition the pump is on totally opposite condition . And control room inside give the stop command into dcs just 1secon relay engage and again normal condition. How can I slove
which type of signal used in instrument?
What is sensitivity in vibration probes..?
How can i copy program (parameter) from mm440 (V.F.D.) by using BOP?
KAlman filter code for two dimension?
key exchanges in wpa,wpa2,tls
how do i tune dearator pr control valve using PID. we set the set point is 0.6kg/cm2 now i want 0.5 to 0.7kg/cm2 limits so what should i give p,i,d values. then pls explain how do set pid values for control valve tuning?
