Answer Posted / 7anoter4
There are generators of which supply voltage is up to 30 kV
[usually 22-23 kV for 500-800 MVA].The problem is the
insulation- will be very expensive for higher voltage-the
generator it self and the auxiliary switchgear and
transformer. A medium voltage generator and a step-up
transformer is cheaper and more convenient for maintaining.
| Is This Answer Correct ? | 17 Yes | 4 No |
Post New Answer View All Answers
difrent between vcb acb sf6 and mccb breakers
take 100kva DTR( delta/wye ), what ll happen if we connect 11kv to LT side instead of connecting to HT side? will the DTR behave as a step up transformer or something else????
suri transmission
what is meant by motor startup supervision & motor load jam protection ?
How to calculate impedance volt in Transformer?
Diagram on interconnectivity of 11kv transformer with RMU (i.e, one incoming and two outgoing or two incoming and one outgoing)
What is diversity factor in electric installations?
What OPGW is better than Microwave or PLCC???
Is it a better option to procure screw type air compressor rather than reciprocating air compressor?If so, what is the reason?How should we select an air compressor(100 CFM)? Please mention the important parameters of air compressor.
Difference between rating factor of cable and derating factor of cable?
Please tell me in DETAIL about the following 3 types of fuses or recommend me a good power system protection book or a website link ? 1.Dropout Fuse 2.Striker Fuse 3.Empulsive fuse (not sure if its impulsive or explosion fuse , sorry)
before synchronizing an alternator,power factor is leading ,why?
How can calculate the earthing strip of Copper/GI for rating of 30kV,discharge current 10KA Lightning arrester.
how to carry out Magnetizing Current Test on Distribution transformer and what purpose we are doing this test. why transformer rating in always in KVA ? what ispositive, negative, zero sequence impedence? How ElCB tripping if Neutral touch with ground Why AC & DC capacitor are use in UPS ? why motor rating in KW? how to syncronize two dg sets
what is the safe meggar values for motor, transformer HT, LT and Cables? IF we want to replace I/C bay at our 220 kv substation which is of 140 mw load capacity bay to be replaced by 400 mw capacity bay.other than CT(1200/1) what are the other equipment i have to replace. why we generally use 3.5 core cable or in other word 1/2 core for neutral and also confirm me that in balance conditiob(3 phase)current in neutral will zero
