Answer Posted / kavin kumar

The kicker get engaed with
the clutch (or) fly wheel
and cranks the engine the
rotating motion is
developed,where the crank
shaft is coupled with
ignition coil due to the
voltage produced in coil is
transfered to spark plug it
ignites the fuel and air in
compression (tdc) ,the
expansion takes place
(these all happends within
a second)...the as we
release the kicker it
disengaed. and the engine
runs ....

What is sae?

1094

---

Is boiler a closed system?

1089

---

What is the reason for emitting the white exhaust smoke during start of the vehicle?

990

---

The point of interaction of the tractive effort curve and the total resistance curve is called a) Stabilizing speed point b) Low speed point c) High speed point d) Normal speed point

1296

---

troubls in inaccurate guage reading

2224

---

Differentiate between hot and cold working of the metals.

1188

---

Will engine performance be damaged by mixing oil in fuel of four stroke bike ?

1117

---

Hi guys! I buyed this clone carprog but i realized that not reading 24cxx. I tried 93cxx and 25cxx and it read.But 24cxx not.I tried to put external power.Of course the eeprom was soldered out.The interface is new and never read 24cxx.I tried many 24cxx .Is there a solution for this problem? I read in other forum that need to replaced 74hc125D with 74hc125M 4 pieces. thanks!

2133

---

What are three methods of heat transfer?

1129

---

What is engine efficiency?

1024

---

Explain the significance of governor in automobiles?

1177

---

Differentiate between two stroke engines four stroke engines.

1166

---

Which would you use - hydraulics or pneumatics?

1099

---

Slip joints are provided in the propeller shaft a) To adjust the inclination of the propeller shaft b) To adjust the length of the propeller shaft c) To prevent the whirling of the propeller shaft d) To adjust the up and down movement of the rear axle

1347

---

What is the function of flux in welding?

1032

---