Interested to Buy Any Domain ? << Click Here >> for more details...
all 3 current transformers (C.T) are burnt in a L.T Panel -
what are the possible reasons
- 5 Answers
- 7295 Views
- I also Faced
- E-Mail Answers
Answer Posted / k.prakashchandra
If measuring cts,may be due to defective rotary phase
selection switch- CTs open circuited
| Is This Answer Correct ? | 2 Yes | 1 No |
Post New Answer View All Answers
how to deside the capacity of chock for drive?
is it possible to have dc motors on single chip
What is Load sharing of Transformer ?
what is the question paper model for section engineer in RRB
A motor running with lenze frequiency inverter stops if I REDUCE SPEED with 25% load.If I run it in High speed and medium speed running smoothly with full load.please help me to solve it.
why swityard is necessrry requirement in any bis power distributin systems?
What happened if C.T mount at any cable or Bus bar in wrong direction . C.T going on proper work or not . C,T direction is essential thing to properly work.
surge tank, hrc fuse, earthing transformer, firm power objective type
What is effect on in zone and out zone fault if CT chosen for phase side is Vk/2<5mA and Neutral side is Vk/2<15mA on REF protection of Transformer
Why we are use dol starter up to 10 hp
WHERE NEUTRAL WIRE IS CONNECTED AT DOMESTIC TO TRANSMISSION LINE(SINGLE PHASE TO THREE PHASE)
WHAT IS DEAD END IN PROTECTION?
why is using sensor?what is differece between photoelectric and proxmitty?
hi friends this is a newcomer in your community of enthusiastic peoples. i am preparing for SSC (CPWD JUNIOE ENGG EXAM FOR ELECTRICAL) pls guide me on the same how to crack it? PLS LET ME KNOW IS ANYONE THERE WHO PASED IT? CAN I GET THE QUESTION PAPERS OF PREVIOUS EXAMINATIONS?
what is mean by drives?
