Interested to Buy Any Domain ? << Click Here >> for more details...
different between calibration range and instrument range ?
- 2 Answers
- 8795 Views
- I also Faced
- E-Mail Answers
Answer Posted / raja
CAlibration range is the range upto which we have marked
readings on a guage ( for e.g) .
Instrument range is the range upto which instrument can
detect measurand .
calibration range is always less than Instrument range.
Dead zone and hysteresis may take position between the
difference in instrument and calibration ranges
| Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
the output of the common trasmitter protocol in qatar gas are the following
How to do gas analysers calibration in AUTO and Manually by using zero and span gas?
What is three element drum level control system why its better than single element?
Explain the difference between mmwc and mmwg?
How to change dcs card in online. (Dsc is maxdna)
The Design Calculation of Level Transmitter For Different Structure open & Closed Vessel, Eg. Diff. Level Tx., Capacitance For Continous Operation
We Have Two Field bus Pressure Transmitters of Different Sensor Range (I.E One is of Lower range and Another is of Higher Range).Is same Process Line. My Question is Can i provide Saturation Limit to my field Bus Transmitter as We can provide Saturation current limit to HART Instruments. As During Low Pressure Both Working OK ,But During High Pressure, transmitter with Lower sensor range Goes to Fault mode as Beyond its Sensor Limit it can Measure, So may I provide Saturation point Some where to Suppress This Fault during High Pressure.
-/5A. What is the meaning and limitations of this in energy meter constant. It is a 3 phase LT Energy Meter. If this Energy Meter is connected through a CT of ratio 200/5 Amps, then what is the multiplying constant and how its will be calculated.
Explain the working of rota meter.
typical loop drawing of a simple feedback control comprising of one transmitter and one control
what is installation and commissioning of (fat & sat) of power plant dcs ? this question keeps in desirable conditions of one company .
i have been asked by QAFCO to appear for interview for thy post of Instrument Designer(INTOOLS)..i m engineering graduate with 5 years exp. in design engineering.Will this job profile suit me??i need all ur help n suggestions for thy same?
how to calibrate corollaries (Mass flow meter)?
what is thermo coupler and how it works
In most instances, Inertia processes are quite uncommon. Give an example of a combined Resistance and Capacitance situation.Describe an application, which according to your understanding of the subject matter, comprises of both Resistance and Capacitance effects.
